You can either update test step result one-by-one, or bulk update all steps result by one click.
 

Update test step result one-by-one:

  1. Launch a test cycle
  2. Click the "Execute" button to open the "Test Case Run" dialog
  3. In the "Run Steps" section, click the "Pencil" icon from the "Result" column for any step
  4. Select a result from the drop-down list
  5. Click the "Close" button to save and close test result, or click "Next" button to save the result and navigate to next test case run.  

[Screenshot - UG0054_Test_Cycle_Test_Step_Result]

Bulk update test step results by one click:

  1. Launch a test cycle
  2. Click the "Execute" button to open the "Test Case Run" dialog
  3. In the "Run Steps" section, click any of below item to update all test steps to the corresponding result:
    NOT TESTED: set all test steps to "NOT TESTED" status
    PASSED: set all test steps to "PASSED" status
    FAILED: set all test steps to "FAILED" status 
    BLOCKED: set all test steps to "BLOCKED" status

    NA: Not Tested, set all test steps to "NA" status
  4. Click the "Close" button to save and close test result, or click "Next" button to save the result and navigate to next test case run. 


[Screenshot - UG0054A_Test_Cycle_Test_Step_Result]